Copper Wood Planter: Mid Century Inspired DIY

Copper Wood Planter: Mid Century Inspired DIY

This copper timber planter is a DIY that i'm very excited about! Im all approximately the mid-century modern look however desired to position my personal twist on it, subsequently the copper. I used undeniable copper bowls I picked up at my local T.J. Maxx – nothing fancy! i really like the hammered look of those copper bowls, specifically against the black wooden.

This copper timber planter appears outstanding status subsequent to any other one on the ground or simply standing to your desk. I’ve protected different methods on making this copper wood planter in case you don’t have access to strength equipment at your home. Don’t fear, I were given your lower back!

keep reading below to find out how to make this copper wooden planter!

observe: I made these distinct methods if you dont have access to a drill so i can explain a way to make it with a drill/energy equipment first and then with out second.

start through measuring out all of your pieces of wood. you will need 4 legs the same length, 1 piece to healthy across (to keep the bowl), and then small pieces the identical length to dissect that. simply as a reference the bigger planter had those measurements: 12 inch legs, 6.25 for the lengthy cross, and 2.five for the smaller cross portions. The smaller planter had nine inch legs and the same measurements for the pass.

be aware: those measurements rely upon the scale of your bowl. My bowl had a diameter of 6 inches so ensure to measure the cross section big sufficient to suit your bowl.

noticed your timber down to your favored measurements. Sandpaper down any tough edges.

measure how a long way down your bowl will rest to your legs and mark every of the legs the usage of a pencil.

Taking your drill, drill a hole thru every of the legs where you just marked.

next, taking your long go beam, drill a small hole into both ends of it (just to make the screw go in simpler).

Taking a screw, drill or hand screw it through one in every of your legs and into one aspect of the pass beam. Repeat this on the alternative side of the move beam. you will end up with a soccer submit type shape.

Taking your smaller cross beam portions, drill a hollow all the manner via horizontally the lengthy manner. try this to both of your small beams.

Taking a very very long screw, drill or hand screw it thru one of the last legs and thru one of the smaller beams all the manner to the standing lengthy go beam. do this with the 4th leg and remaining small beam. You should now have a 4 legged plant stand!

Paint your planter black

To make without any strength equipment:

Do similar to steps 1-three above. notice: if you do not very own a saw you can get wooden cut at home Depot in case you recognize your measurements. as soon as all of your wood is cut to size, seize your wood glue and clamps and possibly a further set of fingers.

Glue your go beam to 2 of the legs where you previously marked. Have your more set of fingers maintain this tightly as then you definitely glue the smaller go beam bits to the their legs and then to the larger go beam.

Take a clamp and wrap it round your four legged planter. allow dry in a single day.

Paint your planter black or some thing shade you need!

Whew! There you've got it, no longer one, but two ways to make this mid-century inspired copper wood planter! As someone who doesnt use strength gear very frequently, I didnt have any trouble with the first technique, plus I simply trust that screws will maintain a hefty plant. but, as long as you have got right clamps, the wood glue approach could be strong too – up to you and your DIY abilties!

Source: here

Leave a comment