DIY Wooden Block Desk Lamp

DIY Wooden Block Desk Lamp

seeking to step up your DIY skills? This easy modern table lamp requires a few simple electric skills that even a newbie DIYer can do. This lamp isperfect for a table, workspace, nightstand or side desk. Small and compact yet precise. customise this project by the usage of a block length that fits the wishes of your area. examine on for how to create your personal!

1. begin with the aid of laying out the design of your lamp. make certain that your timber block is cut right down to size and area a mark in the approximate area wherein you need your light socket.

2. using the forstner drill bit, drill a large hollow at your mark. Depress the bit approximately half of way to 3/4s of the way into the block.

3.turn the block onto it’s facet and use a small drill bit to drill a small hole from the side down into the middle of the block in which your big hollow is. creating a small hole first takes much less force and is extra accurate than the usage of the huge drill bit right of the bat.

4. Repeat step 3 using a larger drill bit (making the hole bit sufficient to bypass your wire thru).

five. Feed your lamp cord up via the holes in the block so that the cord enters the again and feeds out the top of the block.

6. connect your lamp wire to the lamp socket the usage of a screw driver to loosening the screws on the bottom of the socket and wrapping the twine from every side to every person screw. Use your screw driver to tighten the screws again to maintain the wires in area. ensure that the wires aren't touching every different!

7. positioned the socket again over the hollow andhold in region.

eight. the use of the small drill bit, pre-drill a hole on each aspect of the socket where there's a spot to screw it in location.

nine. Screw in your screws to secure the socket at the block.

10. lastly, place a bulb to your socket and plug your twine in to turn to your light! A easy clean bulb or Edison style bulb finishes off the mission nicely!

in case you want to get fancy you could using a mild cord with a switch built into the wire so you don’t ought to plug and unplug your lamp every time you use it.

area your new lamp on your desk and get working!

Source: here

Leave a comment